DevilStars Club Buell Italia

questa è la parte del manuale d'officina che ne parla, purtroppo non so' come salvare le foto (è un pdf) per poterle caricare su imageshack

1. Raise rear wheel off floor using REAR WHEEL SUPPORT
STAND (Part No. B-41174).
2. See Figure 1-22. Slide rubber boot (1) upward to expose
adjuster mechanism. Loosen jam nut (3) from adjuster
(4). Turn adjuster to shorten cable housing until there is a
large amount of free play at clutch hand lever.
3. See Figure 1-19. Remove three fasteners and washers
from clutch inspection cover. Remove clutch inspection
cover and gasket from primary cover.
4. See Figure 1-23. Remove spring (1) and lockplate (2).
Using a flat tip screwdriver, turn adjusting screw (3)
counterclockwise until it lightly bottoms.
5. Turn adjusting screw clockwise 1/4-1/2 turn. Install lockplate
and spring on adjusting screw flats. If hex on lockplate
does not align with recess in outer ramp, rotate
adjusting screw clockwise until it aligns.
NOTE
Spring installs on outboard side of hex lockplate.

io non ho toccato nulla!!senno mica mi lamentavo!!!